Removing the Old Handle
First, remove the door card from your door. This is done by:
- Removing the (clipped in) mirror adjustment cap or blank cover in the top of your door handle/rest
- Removing the three Philips screws which secure the door handle/rest onto the door card
- Unscrewing the door lock pull from the top of the door card
- Removing the door latch frame by unclipping it, sliding it to the side
- Unclipping the door card by gently prying it from around its edges on the bottom and sides of the door
- Lifting off the door card and setting this aside
Next, remove the old door handle by unscrewing the two screws which mount it onto the door, then turning it 90 degrees towards the door lock/latch and sliding it out.
Preparation
To make installation more simple, peel back the clear film on your door, just to the side of the handle cutout. This is where we'll pass the new BLOC handle through and into position.
To prevent scratching of the new handle during installation, it is recommended to apply a small amount of painter's tape to the front of the handle.
BLOC Door Handle Installation
Reinstall the door card components before installing the frame shown below.
